# i2cjig

Components:
* PCB ordered from OSH Park using i2cjig.kicad_pcb
* THT header connector (Sullins Connector Solutions SFH11-PBPC-D10-RA-BK [DigiKey S9205-ND](https://www.digikey.com/en/products/detail/-/1990098))
* THT D-Sub connector (Assmann WSW Components A-DS 15 PP/Z [DigiKey AE10979-ND](https://www.digikey.com/en/products/detail/-/1241793))

Steps:
1. Solder components
2. Remove flux.

# proxdongl3

Components:
* PCB + SMT PCBA ordered from JLCPCB using artifacts in production/
* THT D-Sub connector (Assmann WSW Components A-DF 15 PP/Z [DigiKey AE10934-ND](https://www.digikey.com/en/products/detail/-/1241792))
* THT RJ45 connector (On Shore Technology Inc. PJ012-8P8C1 [DigiKey ED3073-ND](https://www.digikey.com/en/products/detail/-/6566534))
* THT USB Type-A connector (Molex 1050570001 [DigiKey WM8672-ND](https://www.digikey.com/en/products/detail/-/3045207))
* [Glasgow Interface Explorer](https://glasgow-embedded.org/)

Steps:
1. Solder components.  Suggested order: D-Sub, USB shield middle leg, USB shield remaining legs/pins, RJ45.
2. Remove flux.
3. Connect dongle to jig, connect jig to Glasgow, run `glasgow script flash.py i2c-controller -V 3.3`.
4. Test against known good PROXmobil3 + autorun USB.